Device and repair of power units VAZ-2101 Zhiguli

The device and operation of the fuel system
The power system consists of a fuel tank 8 (pic. thirty), fuel lines 4, 11 and 2, fuel pump 1, carburettor 3, air filter, mufflers, intake and exhaust pipes (not shown in the...

The device and operation of carburetors
From the beginning of the production of cars, as the design improved, the following types of carburetors were installed: instead of the carburetor 2101-1107010, since 1974 they...

The device of the exhaust gas system
The release is made through the exhaust pipe, downpipe 2 (pic. 37), additional and main mufflers 5 and 6. A sealing gasket 1 made of asbestos reinforced with perforated steel tape...

Fuel tank — removal and installation
Removal and installation To remove the fuel tank 8 ( see fig. thirty ) drain gasoline, remove the shield, remove the plug 6 of the filler neck and disconnect the wires. Disconnect...

Fuel pump — inspection, disassembly and installation
Examination Insufficient filling of gasoline in the carburetor can be caused by a malfunction of the fuel pump, as well as clogged or damaged fuel lines. To determine the cause of...

Carburetor — removal and installation
Loosen the clamps and remove the crankcase ventilation and air intake hoses from the air filter nozzles. Unscrew the nuts, remove the air filter cover and filter element. Unscrew...

Carburetor — disassembly and check of technical condition
Carburetor repair consists in cleaning it and replacing faulty parts. For disassembly, remove the return spring 7 ( see fig. 32 ). Unpin and disconnect the rod 8. Disconnect the...

Assembling the carburetor setting the fuel level in the float chamber
The carburetor is assembled in the reverse order. float 9 (pic. 42) should rotate freely on the axis and not touch the walls. The needle valve must slide freely in its seat 2. In...

Carburetor adjustments
When installing the pneumatic actuator of the throttle valve of the secondary chamber, turn the shutter of the secondary chamber to a vertical position, press the rod 8 all the...