Removing
1. We install the car on a viewing hole or overpass (see "Vehicle preparation for maintenance and repair").
2. socket wrench for 8 mm unscrew four screws A of the side fastening, four self-tapping screws B of the front fastening and four bolts B of the rear fastening of the mudguard.
3. Remove the mudguard.
4. An additional shield is also installed on a car with an injection engine. It is fastened at the front with bolts for fastening the main shield, and at the back - with two self-tapping screws.
To remove it with a socket wrench for 8 mm unscrew the four bolts of the general fastening of the shields.
5. With the same tool, unscrew the two screws of the rear fastening of the shield.
6. Remove the additional mudguard.
Installation
Shields are installed in reverse order.