Removing
1. We install the car on a viewing hole or overpass (see "Vehicle preparation for maintenance and repair").
2. For ease of access to the upper nut of the generator, remove the battery (see "Battery - removal and installation").
3. socket wrench by 17 mm with a cardan and an extension, unscrew the nut securing the generator to the adjusting bar (key by 13 mm for generator 9412.3701).
4. Remove the mudguard of the engine compartment (see "Mudguard - removal and installation").
5. Remove the belt from the alternator pulley (see "Alternator drive belt - tension adjustment and replacement").
6. Disconnect the wire block from the generator output.
7. Sliding the protective cap, key by 10 mm unscrew the nut that secures the wire ends to the terminal connected to the positive terminal of the battery.
8. socket wrench by 19 mm unscrew the nut securing the generator to the bracket on the cylinder block.
9. After removing the bolt, remove the generator. Be careful not to lose the buffer sleeve A in the cover lug.
Installation
1. Installation of the generator is carried out in the reverse order.
2. Adjust the belt tension (see "Alternator drive belt - tension adjustment and replacement").