Repair of the clutch and its drive VAZ-2105

Clutch device
On VAZ vehicles, a single-plate clutch with a central spring is installed. It is the same on all models. But due to the configuration of VAZ cars with engines of different power,...

Possible malfunctions of the clutch and its drive
Possible malfunctions of the clutch and its drive, their causes and remedies are given in the table.

Removing the clutch and its drive
First of all, drain the fluid from the hydraulic drive, for which put one end of the hose on fitting 9 ( see fig. 112 ) working cylinder, and lower the other into a vessel with...

Dismantling of cylinders of a drive of switching off of coupling
Master cylinder Remove protective cap 17 ( see fig. 111 ) from the cylinder piston, retaining ring 18 and unscrew the plug from the cylinder body. Then remove piston 8, O-ring 7,...

Determination of the technical condition of clutch parts
Check the state of the leading part of the clutch on the base imitating the engine flywheel, with a metal intermediate ring 4 (pic. 113) 8.2 mm thick, replacing the driven disk....

Clutch Release Cylinder Assembly
Assemble the clutch actuator cylinders in the reverse order of disassembly. At the same time, generously lubricate all parts with the fluid used in the clutch drive. When...

Installing the clutch and its drive
Install the clutch on the engine flywheel in the reverse order of removal. Before installing, check the condition of the bearing at the end of the crankshaft. Replace if...

Clutch adjustment and bleeding
Before adjusting, set a gap of 0.1-0.5 mm between the pusher and the master cylinder piston ( see fig. 111 ). This gap, necessary for the complete disengagement of the clutch,...