Execution sequence
1. We install the car on a horizontal flat area. Wheels must be aligned in the straight ahead direction (see "Vehicle preparation for maintenance and repair").
2. We wipe the cover of the crankcase of the steering mechanism with a rag.
3. Use a slotted screwdriver to hook and remove the protective cap from the adjusting screw.
4. Key by 19 mm loosen the adjusting screw.
5. The assistant vigorously turns the steering wheel left and right, at the same time, turning the adjusting screw with a slotted screwdriver, we achieve a decrease in free play to an acceptable limit or a decrease in the force on the steering wheel. When the screw is rotated clockwise, the gap in the engagement decreases, against - increases.
6. While holding the adjusting screw with a screwdriver, tighten the adjusting screw nut. We put on a protective cap.
7. Since the wear of the gearbox worm is greater in the area of the middle position of the steering wheel, we check the ease of turning at the extreme positions of the wheels. In case of jamming, we adjust the engagement in one of these positions.