1. Remove the distributor cap (see "Distributor cap and slider - check and replace").
2. By turning the protective bracket around the axis, we open access to the oiler hole of the roller sleeve.
3. Pour three or four drops of engine oil into the hole, lubricating the roller bearing.
4. Close the hole with a bracket.
5. Lubricate the axis of the moving contact with one drop of engine oil. For clarity, the work is shown on the removed distributor.
6. Saturate the lubricating wick with two or three drops (felt) roller cam.
7. Reinstall the cover of the ignition distributor.
Attention! Do not allow oil to enter the contact group of the distributor in order to avoid failure of the ignition system.