Removing
1. We prepare the car for work (see "Vehicle preparation for maintenance and repair").
2. Special hose (see "Tools, fixtures and operating materials") we pump out gasoline from the tank.
3. Remove the rear lining of the trunk (see "Rear bumper - removal and installation").
4. Using a Phillips screwdriver, unscrew the five screws securing the fuel tank lining and remove it.
5. Having previously marked the location, we shift the protective caps and disconnect the wire ends from the terminals of the level indicator and fuel reserve sensor.
6. Phillips screwdriver or wrench by 8 mm loosen the fuel hose clamp and remove the hose from the fitting. We plug the end of the hose with an M8 bolt.
7. Key by 7 mm unscrew the six nuts securing the sensor and remove the tip A "mass" wires.
8. We remove the level indicator and fuel reserve sensor from the fuel tank. We wash the filter B acetone and blow out the filter tube with compressed air.
9. Remove the ventilation hose from the fuel tank fitting.
10. Turn off the filler cap.
11. Prying with a screwdriver, remove the rubber apron from the tank neck.
12. Key by 10 mm Loosen the fuel tank clamp bolt.
13. We take out the tank from the trunk niche.
14. We take out the bottom rubber gasket.
Installation
1. If the tank was not removed for replacement, we wash it from the inside with gasoline or solvent.
2. Install all removed parts in reverse order.