Removing
1. We install the car on a viewing hole or overpass (see "Vehicle preparation for maintenance and repair").
2. Drain the fluid from the hydraulic clutch release (see "Clutch release hydraulic - fluid change and bleeding").
3. Disconnect the rubber clamp securing the coolant expansion tank and move the tank to the side (see "Expansion tank - replacement").
4. Open end wrench by 13 mm unscrew the fitting of the pipeline, holding the tip of the brake hose from turning with an open-end wrench by 17 mm. We pull the pipeline a little up and take it to the side.
5. Using pliers, remove the bracket for attaching the hose to the bracket and remove the hose tip from it.
6. Key by 17 mm unscrew the hose end from the clutch slave cylinder.
Warning! There is an o-ring in the connection between the tip and the cylinder, do not lose it.
Installation
1. Install the hydraulic hose in reverse order.
2. Fill the liquid into the tank to the required level and pump the hydraulic drive (see "Clutch release hydraulic - fluid change and bleeding").