Car doors and windows VAZ-21061 «Zhiguli»

Windshield replacement
This work should be done by two people. Using a Phillips screwdriver, unscrew the three screws... ...and remove the windshield pillar trim. Similarly, remove the lining of the...

Door upholstery replacement
Using a screwdriver, remove the armrest cover. Using a Phillips screwdriver, unscrew the three screws securing it through the holes in the armrest and remove the armrest. We...

Rear Door Exterior Handle Replacement
Removing the door trim (see Door upholstery replacement ). Prying with a screwdriver, disconnect the drive rod from the lock (see Rear door lock actuator replacement ). Using a...

Front door outside handle cylinder replacement
Removing the door trim (see Door upholstery replacement ). Removing the door lock (see Replacing the front door lock ), leaving the lock retainer on the stand. key «for 8» unscrew...

Replacing the front door lock
Raise the glass and remove the door trim (see Door upholstery replacement ). On the end side of the door with a Phillips screwdriver, unscrew the two screws securing the rear...

Replacing the front door sliding glass
Raise the glass and remove the door trim (see Door upholstery replacement ). Removing the front groove (see Replacing the front door lock ). We lower the glass. Using a Phillips...

Replacing the swing glass of the front door
Removing the sliding glass from the door (see Replacing the front door sliding glass ). We take out the upper seal of the sliding glass. Using a Phillips screwdriver, unscrew the...

Door Window Lifter Replacement
Removing the glass from the door (see Replacing the front door sliding glass and Replacing the sliding and fixed glass of the rear door ). To prevent the power window cable from...

Replacing the door and door stop
With pliers we squeeze the branches of the door stop and remove them from the holes of the bracket. key «on 10» remove two bolts... ... and remove the limiter from the door. While...

Door adjustment
The gaps around the perimeter of the door should be the same. To adjust the height, loosen the screws of both hinges and move the door vertically. Holding it in the required...

Rear door lock actuator replacement
Removing the door trim (see Door upholstery replacement ). Disconnect the drive rod clamp from the sliding glass guide. Disconnect the drive rod from the lock with a slotted...

Replacing the sliding and fixed glass of the rear door
Raise the glass to the top position. Removing the door trim (see Door upholstery replacement ). Disconnect the lock drive rod from the guide groove (see Rear door lock actuator...

Trunk upholstery replacement
We pry with a slotted screwdriver or, by pulling the mat, disconnect the two plastic buttons for the rear fastening of the trunk mat. In the same way, we disconnect the three...

Replacing the trunk lid lock
socket wrench «on 10» loosen two screws... ... and remove the trunk lid lock with a spring. We take out the lock drive from the hole... ...and remove the o-ring. After noting the...

Replacing the trunk lid seal
We begin to remove the seal from the flanging from the joint. We skip the new seal behind the trunk lid hinges,... ... evenly distribute it around the perimeter of the opening,...

Trunk lid replacement
Removing the trunk lid lock (see Replacing the trunk lid lock ). key «on 10» unscrew the two nuts securing the cover to the right and left hinges and remove the trunk lid. We...