Electrical equipment of car engine VAZ-21061

Accumulator battery — check
Cars are equipped with a lead starter battery 6ST-55P or its analogues. The battery consists of six series-connected batteries placed in separate compartments of a common body...

Description of the generator design
Generator G-221 1 - clamping sleeve; 2 - bushing; 3 - buffer sleeve; 4 - back cover; 5 - screw fastening the rectifier unit; 6 - rectifier block; 7 - valve (diode); 8 - rear...

General information about the generator
The car is completed with the G-221 generator. This is a three-phase synchronous electric machine with electromagnetic excitation and a built-in silicon diode rectifier. The...

Generator check
For clarity, the photos were taken on the removed generator, but the test can also be carried out on the car. Disconnect wires from battery and alternator (see Removing the...

Replacing the alternator drive belt
For convenience, remove the battery. head «at 17» loosen the nut securing the generator to the adjusting bar (The battery has been removed for clarity). With a mounting blade, we...

Replacing the voltage regulator
The regulator is fixed with two nuts on the left mudguard. head «for 8» unscrew the two nuts and remove the regulator. Disconnect two wires. We fasten the new regulator to the...

Generator brush replacement
Generator brushes are replaced as an assembly with a brush holder. For clarity, we show the operation of replacing the brushes on the removed generator, but they can also be...

Removing the generator
It is more convenient to carry out work on a viewing ditch or a lift. For clarity, some of the operations are shown on a generator removed from the engine or with engine parts...

Generator repair
Removing the generator from the engine (see Removing the generator ). key «on 10» loosen the nut... ... and remove the insulating washer from the output «30» generator. key «at...

Description of the starter design
Starter 35.3708 assy 1 - cover on the drive side; 2 - retaining ring; 3 - restrictive ring; 4 - drive gear; 5 - overrunning clutch; 6 - driving ring; 7 - rubber plug; 8 – drive...

Starter Replacement
key «on 10» unscrew the bolt of the lower fastening of the heat shield of the starter (it is located in an inaccessible place)... ...and take it out. Remove the hose from the warm...

Starter repair
Removing the starter from the engine (see Starter Replacement ). key «at 13» loosen the nut securing the wire to the traction relay... ...and disconnect the wire end. We apply a...