Lighting and signaling of cars VAZ-21061

Headlights — general information
Four headlights are installed on the VAZ-2106 car. When the low beam is on, the external headlights work, when the high beam is on, all four. The two outer headlights use...

Headlight adjustment
Headlight switching circuit 1 - headlights; 2 - fuse block; 3 - speedometer with signaling device for switching on the main beam of headlights; 4 – the relay of inclusion of a...

Replacing the headlight reflector bulb
Removing headlight covers (see Radiator Grille Replacement ). Using a Phillips screwdriver, loosen the three screws securing the headlight reflector bezel (on the example of an...

Headlight replacement
In the engine compartment, disconnect the two tips of the green wire from the high beam headlight. Removing headlight frame (see Radiator Grille Replacement ). Using a Phillips...

Exterior lighting, braking, fog and reversing lamps
Scheme for switching on outdoor lighting 1 - front lights with side light lamps; 2 - storage battery; 3 - generator; 4 - engine compartment lamp; 5 - fuse block; 6 - brake signal...

Hazard and direction indicators
Scheme of the alarm system and direction indicators 1 - front lights with direction indicator lamps; 2 - storage battery; 3 - generator; 4 - side direction indicators; 5 - main...

Replacing headlight and front turn signal bulbs
Loosen the two screws securing the headlight diffuser. We remove the diffuser and replace the faulty lamp. We install the diffuser in place and wrap the screws.

Sidelight replacement
If the car has a fender liner, remove it. On the inside of the wing socket «for 8» unscrew the two nuts securing the sidelight, after wetting the thread with kerosene or WD-40,......

Replacing the side indicator lamp
If the car has a fender liner, remove it. On the inside of the wing, remove the protective cover from the direction indicator housing, remove the cartridge and replace the faulty...

Side turn signal replacement
Take out the bulb holder (see Replacing the side indicator lamp ). From the inside of the wing with a key «for 8» unscrew the two nuts securing the pointer, holding it from the...

Replacing bulbs in the rear lights
From inside the trunk, unscrew the plastic nut. We remove the diffuser and change the faulty lamp. To replace the lamps of the right lamp, first remove the gas tank cover (see...

Replacing taillights and license plate lamps
Removing trunk lining (see Trunk upholstery replacement ). We mark the wires or remember the order in which they are connected. Disconnect connector... ... and four tips from the...

Replacing the fog light bulb
Using a Phillips screwdriver, unscrew the two self-tapping screws,... ... remove the diffuser and change the faulty lamp. We install the diffuser in place and wrap the screws.

Fog lamp replacement
After removing the protective cover, disconnect the tip from the lamp output. key «on 10» unscrew the two bolts securing the lamp to the rear bumper... ...and take it off. Install...

Replacing the interior lamp
Prying off the bottom with a screwdriver... ... take out the ceiling lamp interior.. and replace the lamp. We install the cover by pressing on its upper part until the spring...

Replacement of switches and ceiling lamps for interior lighting
Replacing door switches... ... use a Phillips screwdriver to unscrew the screw,... ... take out the switch and disconnect the wire from it. Install the new switch in reverse...

Glove box lamp replacement
Having opened the glove box, we take out the cartridge together with the lamp from the switch housing. We change the faulty lamp and install the cartridge in place.

Replacing the engine compartment lamp and its switch
To replace the bulb, press lightly on it and turn it counterclockwise to remove it. The lamp switch and its cartridge are made in a common housing. To replace it... ... disconnect...

Replacing the brake light switch
Under the dashboard on the driver's side... ...remove two plugs from the switch terminals. key «at 19» unscrew the plastic buffer... ...and take it off. We loosen the locknut and...

Replacing paddle shifters
The car uses a three-lever steering column switch mounted on the steering column. The switches for the direction indicator, headlights and the operating mode of the cleaner and...

Trunk Light Bulb Replacement
Disconnect the wire end. Sliding the lamp shade in the grooves of the bracket, remove it. We take out the socket with the lamp from the ceiling... ...and replace the faulty lamp....

Replacing the clock backlight
We take out the clock from the fixing finger in the panel (help with a screwdriver if necessary). The ring may move with the watch. We take out the cartridge and change the faulty...

Watch replacement
Removing the clock from the dashboard (see Replacing the clock backlight ). Having taken out the watch, we disconnect the wire ends, remembering or marking the order of their...

Sound signal
Scheme for switching on sound signals 1 - sound signals; 2 - relay for turning on sound signals; 3 – the switch of sound signals; 4 - fuse block; 5 - generator; 6 - battery. Sound...

Adjustment and replacement of a sound signal
Removing the radiator grill (see Radiator Grille Replacement ). We remove the tip of the wires from the conclusions of the sound signal. key «at 13» unscrew the nut securing the...