Removing
1. We prepare the car for operations (see "Vehicle preparation for maintenance and repair").
2. Install the glass in the lower position.
3. Remove the upholstery of the rear door in the same way as removing the front (see "Front door upholstery - removal and installation").
4. Remove the protective film of the door.
5. Using a Phillips screwdriver, unscrew the self-tapping screw securing the rear upper guide of the sliding glass.
6. Remove the seal from the top of the door frame.
7. Using a 10 mm socket or spanner wrench, unscrew bolt A and nut B for fastening the rear guide.
8. Remove the upper part of the guide from the fixed glass seal.
9. Tilt forward the upper part of the fixed glass, take it out.
10. Remove the seal from the fixed glass.
Attention! Before performing the next operation, it is recommended to note the position of the cable relative to the pressure plate.
11. Using a Phillips screwdriver, unscrew the two screws securing the cable pressure plate to the glass bracket.
12. Remove the plate and lower the glass until it stops.
13. Remove the door trim and two chrome trim (see "Front door glass - removal and installation").
14. Raising the sliding window with the bracket and tilting it inward, we take it out of the door.
Installation
The rear door windows are installed in the reverse order, guided by the previously marked mark on the cable.