Removing
1. We prepare the car for operations (see "Vehicle preparation for maintenance and repair").
2. Disconnect the wire from the negative battery terminal (see "Battery - removal and installation").
3. Moving upwards, remove the tank from the protrusions of the bracket.
4. Disconnect the wire ends from the electric pump plugs. The yellow-black wire is connected to the side (positive) output, and gray-black - to the central (negative) conclusion.
5. Remove the tube from the pump fitting. If there is washer fluid in the reservoir, tilt the reservoir to prevent leakage. Opening the tank lid, drain the liquid into a previously prepared container.
6. Using a screwdriver, remove the electric pump from the rubber seal in the tank.
The sealing ring must be elastic and not have cracks, if necessary, pry it with a slotted screwdriver, remove it and replace it.
Installation
Advice. Before installing the tank on the bracket, in order not to damage the wall of the tank, we clean the edges of the bracket from burrs with coarse-grained sandpaper and dull the sharp edge with a file.
Install all removed parts in reverse order.