Removing
1. We prepare the car for operations (see "Vehicle preparation for maintenance and repair").
2. Relieve pressure in the power system (see above, "Pressure relief in the power system).
3. Disconnect the wire from the negative terminal of the battery (see "Battery - removal and installation").
4. Key by 17 mm unscrew the fuel pipe fitting, holding the filter with a wrench by 19 mm.
Attention! A small amount of gasoline may leak. Put on a rag.
5. Disconnect the tube from the filter.
Two sealing rings are installed in the connections of the tubes with the filter.
6. Similarly, disconnect another tube from the filter.
7. Using a 10 mm socket wrench, loosen the coupling bolt of the filter mounting clamp and remove it.
Installation
1. Filter installation is carried out in reverse order. In this case, the arrow on the filter housing must be directed towards the fuel rail.
2. We replace the rings sealing the connections of the filter with fuel pipes.
3. With the engine running, we check the tightness of the filter connections with the tubes. In case of leakage, tighten the pipe fittings.