Rear axle, gearbox and axle shafts VAZ-2107

Description of the design of the rear axle
Rear axle: 1 - half shaft (2103-2403069); 2 - rear axle beam (21012401010-01); 3 - breather (2101-2401050-01); 4 - nut of the shank of the drive pinion M16x1.5 (12574921); 5 -...

Rear axle — checking the level and changing the oil
To perform the work, you will need a container for draining oil with a volume of at least 1.5 liters. Checking the oil level 1. We install the car on a viewing hole or overpass...

Final drive gear oil seal — replacement
You will need a two-jaw puller and a torque wrench to get the job done. We replace the oil seal with a new one if oil leaks from under the drive gear shank are detected. This is...

Axle — removal and installation, replacement of the oil seal
We replace the axle shaft with the bearing when it is deformed or the bearing is heavily worn, which is expressed in a noticeable axial play of the suspended wheel. The axle shaft...

Rear axle gearbox — removal and installation
We remove the gearbox if it is necessary to repair or replace it. Removing 1. We install the car on a viewing hole or overpass (see " Vehicle preparation for maintenance and...

Rear axle — removal and installation
We remove the rear axle to replace it or carry out body work. An assistant is required to complete the work. Removing 1. We install the car on a viewing hole or overpass (see "...