Repair of interior elements of cabin VAZ-2108

Upholstery — design description
To reduce weight, heat and noise insulation, the roof upholstery is made of polyurethane foam type «Bynat» one-piece molded with fiberglass on both sides. From the side of the...

Dashboard — design description
Pic. 166. Dashboard: 1 - instrument panel overlay; 2 - instrument panel seal; 3 - lock spring; 4 - axis of the castle; 5 - glove box cover lock; 6 - glove box cover; 7 - axes of...

Front seats — design description
Pic. 167. Front seat: 1 - pillow base; 2 - pillow; 3 - back; 4 - headrest; 5 - head restraint frame; 6 - headrest guide; 7 - cotter pin; 8 - lining of the backrest tilt lever; 9 -...

Rear seat — design description
Cushion and backrest bases are stamped from sheet steel. Cushion and backrest have two welded loops, which are attached to the floor of the body. To increase the area of the...

Heating and ventilation of the cabin — description of the design
Heating is provided by air heated in a radiator 13 (pic. 170) heater, which is included in the cooling system parallel to the main radiator. Outside air passes under the hood into...

Removal and installation of an upholstery of a roof
Unscrew the self-tapping screws and remove the sun visors. Remove the facing parts for fastening the handrails with hooks for clothes, unscrew the screws and remove the handrails....

Removal and installation of an upholstery of racks
The upholstery of the pillars of the wind window is removed by unscrewing the self-tapping fastening screws. To remove the upholstery of the central pillar, take out the...

Removal and installation of an upholstery of forward doors and sidewalls
To remove the door upholstery, press the socket and shift the trim of the handle 9 ( see fig. 159 ) window regulator until it is completely out. Remove the handle and trim. The...

Removal and installation of the instrument panel
Disconnect the negative cable from the battery. Unscrew the fastening screws and remove the steering shaft cover and the ignition lock cover. Remove the handles from the heater...

Removal and installation of a forward seat
Move the seat to the extreme forward position and remove the torsion bars 22 ( see fig. 167 ). The seat is shifted to the rearmost position, the nuts of the studs 21 for fastening...

Removal and installation of a back seat
Unscrew the two screws securing the pillow hinges and remove the pillow from the passenger compartment. Press the lock drive handle and release the seat back. Unscrew the two...

Removal, dismantling, assembly and installation of the heater electric fan
Before removing the electric fan assembly, disconnect the negative cable from the battery. Remove the fastening brackets and take out the water deflector 1 ( see fig. 172 ) and...

Removal and installation of a heater
Removal of the heater is carried out after removing the instrument panel (see sect. «Removal and installation of the instrument panel»). Move lever 18 ( see fig. 171 ) heater...

Disassembly and assembly of the heater
Disconnect the fastening brackets of the shells of the rods 1, 7, 12, 19 ( see fig. 171 ) on the heater casings and remove the rods from the damper drive levers. Loosen hose...