Clutch and wheel drive repair VAZ-2108

Features of the clutch device
Dry clutch, single disc, with central pressure spring 11 (pic. 57). The clutch cover is attached to the flywheel with six bolts, and is connected to the pressure plate S by three...

Removing the clutch and its drive
Remove gearbox first (see sect. « Transmission »). Then unscrew the bolts securing the clutch cover to the flywheel and remove the clutch cover assembly with the pressure plate....

Checking the technical condition and checking the clutch
Check the status of the slave drive. Friction linings are replaced with new ones when cracks appear, the distance between the rivet and the working surface decreases to 0.2 mm, as...

Possible malfunctions of the clutch and its drive
Possible malfunctions of the clutch and its drive

Installing the clutch and its drive
Installation of the clutch and its drive is carried out in the reverse order of removal. Wherein: check the condition of the splines on the hub of the driven disk and on the input...

Clutch release lever free play adjustment
Free travel on lever 19 ( see fig. 58 ) in the initial position of the drive should be 3.5-4.0 mm. It is adjusted with nuts 5, changing the position of the lower branch of the...

Features of the drive shaft device
The drive of each wheel consists of two hinges of equal angular velocities and a shaft 10 (pic. 76), which is solid for the left wheel drive, and tubular for the right. Pic. 76....

Removal and installation of a drive of wheels
Install the car on a lift or inspection ditch and perform the following operations on both sides of the car: loosen the front wheel mounting bolts, remove the hub cap and unscrew...

Disassembly and assembly of the wheel drive
Disassembly of the outer hinge Disassembly of the hinge is carried out only in case of damage to the protective cover 8 ( see fig. 76 ), when it becomes necessary to change the...