Vehicle maintenance VAZ-2110

Engine lubrication system
When the engine is running, engine oil consumption is normal. The amount of oil consumption depends on the driving style of the car and is determined by the load on the engine and...

Transmission
Checking the oil level is carried out on a cooled box. The oil level must be between the two indicator marks 2 (pic. 42). Topping up oil is carried out in small portions through...

Engine cooling system
Checking the coolant level in the expansion tank 1 (pic. 43) carry out only on a cold engine. The fluid level should be at mark A (top edge of recess for fastening belt). During...

Brake system
Brake fluid level in reservoir 2 (pic. 44), installed on the main brake cylinder 1, is checked visually by the marks on the tank body, made of translucent plastic. With cover 3...

Power steering
To ensure the normal operation of the hydraulic power steering (installed as a variant) it is necessary to regularly check the level of the working fluid in the tank 2 (pic. 45)...

Washer fluids
Liquid level in tanks 1 (pic. 46) and 2 washer wind and rear (for cars LADA 111, 112) glass must always be sufficient, you should not wait for the sensor 4 of the low level...

Battery and its charging
The electrolyte level must be between the marks «MIN» (pic. 47) And «MAX», printed on the translucent battery case. Deviations from the specified parameters of the electrolyte...

Tire and wheel maintenance
Periodically check the air pressure in the tires with a pressure gauge (see table. 4). Operating tires with pressures other than those recommended will result in premature tire...

Wheel replacement
To change wheels: park the vehicle on a level surface and apply the parking brake and engage first gear; remove the spare wheel and tool; loosen one turn with combination wrench 2...

Lighting and signaling lamps
For normal operation of the lighting and signaling system, use the lamps specified in annex 2 . To replace the lamp 1 (pic. 51) dipped or main beam in the headlamp, turn cover 3...

Fuses
To access mounting block 5 (pic. 59) press button 1 and, holding cover 4, slowly lower it down. In the mounting block, relays 2 for various purposes and fuses 3 are installed. A...

Replacing the battery of the remote control for locking and unlocking doors
The remote control contains a lithium battery type CR2032, with a voltage of 3 V. If the supply voltage is within the normal range, then each time you press any button on the...

Car body maintenance
The body is the basic and most expensive element of the car. It is made of modern materials and protected from corrosion by high-quality protective agents. The basis for the...

Car storage
In operation, pay great attention to the storage conditions of the car. The optimal storage conditions for a car are: a canopy where the temperature and humidity correspond to the...