In the variant version, the cars are equipped with an electric drive for adjusting the exterior mirrors (see fig. 34, 35).
Interior mirror 1 (pic. eleven) rear view, adjust by turning around the hinge head. At night, if the headlights of a car moving behind interfere, you can change the position of the mirror with lever 2.
Individual lighting dome 3 is used for directional illumination of individual objects (maps, road atlas, etc.). The plafond can deviate in all directions. Turning on and off the ceiling is carried out by a slight rotation of the tube around the axis.
When you open the side doors of the car, the interior lighting automatically turns on. With the doors closed, the interior light is turned on and off by pressing the ends of the diffuser.
On vehicles equipped with the APS-4 electronic anti-theft system, a delay mode for turning off the interior lighting and illumination of the ignition switch socket is set. For this mode to work, the ceiling switch must be in the position «turned off», i.e. the ceiling lamp should light up at the moment the door is opened. In this state, if the ignition is not turned on, after closing the driver's door, the ceiling lamp continues to burn for another 10-12 seconds and then smoothly goes out. The delay mode can be interrupted if the ignition is switched on with the driver's door closed.
Sun visors 4 can take the following positions:
- A - starting position;
- B - in the opposite direction of the sun's rays;
- C - with lateral direction of sunlight.
In a variant version, the passenger's visor has a mirror on the inside.
To open the glove box lid 2 (pic. 12), it is necessary to squeeze the keys of the lock 1 to the stop and pull it towards you. When the lid is open, the inside of the glove box is illuminated by a lantern 3 if the ignition is on.
In LADA 111, 112 vehicles, it is possible to install acoustic devices of radio equipment also on the trunk shelf supports.
In the variant version, a wiring harness is installed on the cars to connect acoustic devices in the front doors and rear of the cabin. Work on the installation and connection of radio equipment is recommended to be carried out on SSSS, which have special equipment and tools.
In a variant version, quartz car clocks are installed on cars (pic. 13).
To set the arrows to the desired position, pull the handle 1 and rotate it in any direction. When the car is equipped with a push-button clock (electronic) moving the hands when pressing the transfer button for less than 1 second, the hands move one minute division with each press, while holding the button for more than 1 second, the hands move rapidly in the direction of the hour hand at a speed of 8 divisions per second. In any case, the countdown of seconds starts at the moment the transfer button is released.