Removing
1. We prepare the car for work (see "Preparing the car for maintenance and repair").
2. Remove the right and left lining of the center console (see "Dashboard - removal and installation").
3. Move the front seats forward until they stop.
4. Using a Phillips screwdriver, unscrew the two self-tapping screws of the rear fastening of the upper part of the lining on both sides of the ashtray.
5. We shift the seats back to the stop.
6. With a special angle screwdriver or by unscrewing four nuts securing the front seats (see "Front seat - removal and installation") and tilting the seats back, unscrew the two screws of the middle fastening of the upper part of the lining.
7. Prying with a slotted screwdriver, remove the power window switch panel.
8. In order not to confuse during assembly, we mark the connecting blocks of the switches.
9. With a thin slotted screwdriver, pressing the latches, disconnect the pads from the switches.
10. Raise the parking brake lever.
11. With the same screwdriver, we press the latches of the parking brake lever frame and disconnect it from the floor tunnel lining. Move the frame up the lever.
12. Similarly, remove the cover of the gear lever.
13. With a jerk upwards, remove the gear lever handle together with the cover.
14. Disconnect two pairs of cigarette lighter wire blocks (see "Dashboard - removal and installation").
15. Raising the rear part of the upper lining of the floor tunnel, move it back, disengaging the front part of the lining from the center console.
16. socket wrench by 10 mm unscrew the nut securing the air duct.
17. Remove the air duct, bringing its front part out of the hole in the bottom of the floor tunnel lining.
18. socket wrench by 10 mm unscrew the six nuts securing the lower part of the tunnel lining (two nuts - in front of the lining, two - in the back and two near the gear lever).
19. Remove the lower part of the lining.
Installation
Install pads in reverse order. When connecting the pads of the wiring harnesses to the switches, we are guided by the marks made during disassembly.