You will need: key «on 10», screwdriver.
1. Disconnect the wire from the terminal «–» battery.
2. Open the hood and remove the cover from the relay and fuse box by depressing the four plastic latches.
3. Move the rubber boot and disconnect the upper block of the wiring harness from the block.
4. Turn away two nuts of fastening of the block.
5. Remove the unit from the compartment in front of the windshield, as far as the wires allow, and disconnect the lower blocks of the wiring harnesses from it.
Helpful advice. Mark the blocks of the wiring harnesses of the unit - this will facilitate the work when reinstalling.
6. Install the relay and fuse box in the reverse order of removal. After installation, check the operation of the electrical equipment.