Windshield replacement

To replace damaged glass, remove the wiper arms, the seal bezel and, by pressing on the upper corners of the glass, squeeze it out. At the same time, the Assistant must support the glass from the outside (pic. 8-23).



Remove the seal from the glass.

Install the windshield as follows:

• wash the grooves of the seal 9 with water (rice. 8-9) and blow with compressed air;
• put the seal on the glass;
• moisten the groove of the seal 2 (pic. 8-24), with which it is put on the body flange, with glycerin or soapy water;
• insert cord 1 into the groove with a screwdriver;
• install the glass in the opening of the body and then, pulling the ends of the cord 1 from the seal inside the body, make sure that the glass with the seal 2 sits in place. In this case, the assistant should slightly press on the glass from the outside. If the glass is not installed, check the dimensions of the body opening using glass without a seal. Eliminate deviations in the dimensions of the opening by straightening.