Carburetor assembly

Assemble the carburetor in the reverse order of disassembly. In doing so, pay attention to the following points.

The float should rotate freely on its axis without touching the walls of the chamber.

The needle valve must slide freely in its seat, without distortion or binding, the tightening torque of the needle valve seat must be 14.7 Nm (1.5 kgf·m).

Solenoid shutoff valve tightening torque must be 3.68 Nm (0.4 kgf·m).

In order not to confuse the jets during assembly, pay attention to the marking of the jets and, when installing them, be guided table 2-2.

Before installing axle 19 (see fig. 2-88) lubricate the end of the axle and the extreme 1-1.5 turns of the thread with UG-9 sealant.

When assembling the accelerator pump, tighten the cover fastening screws, press the drive lever all the way, tighten the screws and release the lever.