We pry with a slotted screwdriver..
... and remove the inner glass seal.
Remove the outer glass seal in the same way.
We take out the protective film.
Through the window of the inner door panel, use a Phillips screwdriver to unscrew the two screws of the front..
... and two screws for the rear window cable to the glass holder.
Lowering the front end of the glass inside the door,..
... take out the glass.
If the glass purchased to replace the broken one does not have clips with brackets, then we clean the old clips from glass fragments and the old rubber gasket. We put marks on the new glass so that..
... so that the distance from the rear end of the glass to the rear end of the front glass clip is 400 mm,...
... and to the rear end of the rear clip - 125 mm.
To install the holders, we cut out two pieces of new raw rubber.
We dip one piece of raw rubber into a container of gasoline..
... and install on the glass according to the marks.
We lean the glass on a soft base..
... and gently press the clip with raw rubber onto the glass with a hammer.
Similarly, we press the second clip along the marks.
Before installing glass..
... check the condition of the rubber glass buffer.
Install glass in reverse order.