Removing the radio mount panel (see Removing the radio mounting panel).
head «on 10» unscrew the nut of the relay-interrupter of the direction indicators and alarms..
... and remove the tip from the stud «negative» heater fan motor wires (black color).
Attention! Two more terminals are attached to the same stud «minus» wires.
In photo 1–2, the instrument panel has been removed for clarity.
On the right side of the fan casing, we release the rod from under the spring clamp.
We pry with a slotted screwdriver and disconnect four (two on each side) spring brackets for fastening the fan casing.
Remove the fan shroud, guide shroud and the fan itself.
Remove the guide shroud from the fan shroud.
We pry with a slotted screwdriver and disconnect the two spring brackets for mounting the fan.
Disconnect the fan wire from the additional resistor..
... and remove the fan from the casing.
Remove rubber motor mounts.
We pry the lock washer with a slotted screwdriver..
...and take it off.
Remove the fan impeller.
We assemble and install the heater fan in the reverse order.