Electrical equipment and appliances VAZ-1111 Oka

Car wiring diagram
The electrical equipment is made according to a single-wire circuit - the negative terminals of the sources and the corresponding terminals of the consumers of electricity are...

Device features lighting and signaling
Headlights The scheme of inclusion of headlights is shown in fig. 158. The dipped and main beam headlights are switched on using auxiliary relays 3 and 11. The control voltage to...

Possible malfunctions of lighting and light signaling
Individual headlights or taillights do not light up Lamp filament burnt out - Replace lamps. Fuse blown - Replace the appropriate fuse. Oxidation of switch or relay contacts, lamp...

Adjustment and repair of lighting and light signaling devices
The direction of the light beams of the headlights should be such that the road in front of the car is well lit, and the drivers of oncoming vehicles are not blinded when the...

Windshield wiper and washer
Windshield wiper type 45.5205 consists of a gearmotor (electric motor with gearbox), lever drive and brush lever. The scheme of inclusion of a cleaner and a washer of a windscreen...

Possible malfunctions of the windshield wiper
Possible malfunctions of the windshield wiper, their causes and methods. The purifier does not work, the fuse in it does not work Damage to the power wires of the cleaner,...

Removal and installation of a cleaner of a windscreen
The repair of the cleaner consists mainly in editing the deformed parts of the lever mechanism or replacing them with new ones. It is recommended to replace a defective gearmotor...

Dismantling, assembling and checking the windshield wiper gearmotor
To disassemble the gearmotor, remove the panel with the contacts of the limit switch from the cover, unscrew the screws securing the gearbox cover and remove it together with the...

Checking the windshield wiper relay
Relay type RS-514 is used to obtain intermittent operation of the windshield wiper. It is installed under the instrument panel on the left side and is attached to the body with...

Wiper, washer and heated rear window, cigarette lighter
Rear window cleaner. Consisting of gearmotor type 471.3730, lever and brush. Laying the lever with a brush - right in the direction of the car. The gearmotor has a thermal...

Electric motors of fans
Heater To drive the fan, an ME-255 direct current electric motor with excitation from permanent magnets is used. When an additional resistor is included in the power supply...

Features of the device control devices
All control devices of the car are united in a combination of devices. It includes: speedometer with distance meter, coolant temperature gauge. fuel level indicator with a reserve...

Removal and installation of a combination of devices
To remove the instrument cluster, open the hood and disconnect the wire from the terminal «minus» battery. Disconnect the speedometer flexible shaft from the drive on the gearbox....

Disassembly and assembly of the instrument cluster
For disassembly, the welt brackets are bent and carefully removed with glass and frame. Unscrew the screws securing the speedometer scale, and then unscrew the two screws securing...

Instrument Troubleshooting Technique
Coolant temperature gauge If the pointer needle is constantly at the beginning of the scale, then with the ignition on, disconnect the wire from the pointer sensor and connect the...

Checking devices and their sensors on the stand
Coolant temperature gauge. The device operates in conjunction with a sensor installed in the cylinder head. With a sensor resistance of 1000-5000 ohms, the arrow should be at the...