![](https://www.vazbook.ru/img/vaz_1111/3275.jpg)
1. Remove the caliper without disconnecting the brake hose from it, and hang it on a rope or wire to the front suspension spring (see subsection 7.1.1 for details.).
![](https://www.vazbook.ru/img/vaz_1111/3276.jpg)
2. Remove guide pins (here and below operations are shown on the example of one finger).
![](https://www.vazbook.ru/img/vaz_1111/3277.jpg)
3. Remove the protective cover from your finger.
![](https://www.vazbook.ru/img/vaz_1111/3278.jpg)
4. Clean the guide pin and the hole for it in the shoe guide from dirt and old grease. There should be no signs of corrosion or damage on the finger. Otherwise, replace the guide pin.
![](https://www.vazbook.ru/img/vaz_1111/3279.jpg)
5. Check: the finger should move freely, without jamming, in the guide hole.
![](https://www.vazbook.ru/img/vaz_1111/3280.jpg)
6. Be sure to replace a torn, cracked, or loose guide pin guard.
![](https://www.vazbook.ru/img/vaz_1111/3281.jpg)
7. Install the protective cover on the finger by sliding the edge of the cover over the shoulder of the finger.
![](https://www.vazbook.ru/img/vaz_1111/3282.jpg)
8. Before installing the finger, lubricate it with Litol-24 grease or graphite grease.
![](https://www.vazbook.ru/img/vaz_1111/3283.jpg)
9. Insert your finger into the shoe guide hole by sliding the edge of the boot over the guide shoulder. Install the caliper, wheel and check the operation of the brake system.