Car ignition system VAZ-11113 «Ока»

Setting the ignition timing
Location of spark torque sensor: 1 – sparking torque sensor; 2 - vacuum regulator; 3 - hatch cover in the clutch housing; 4 – the case of a drive of auxiliary units of the engine...

Checking the Spark Torque Sensor
Location of spark torque sensor: 1 – sparking torque sensor; 2 - vacuum regulator; 3 – the case of a drive of auxiliary units of the engine You will need: screwdriver 15 V...

Removal and installation of the spark moment sensor
You will need a key "on 10". Disconnect the wire from the terminal "–" battery. Remove the air filter. 1. Mark the position of the spark torque sensor relative to the accessory...

Repair of spark torque sensor
You will need: screwdriver a pointed tool like an awl goatee hammer Remove the spark torque sensor from the vehicle ( see subsection 8.4.3. ). 1. Carefully, without using any...

Checking and replacing the ignition coil
You will need: key "on 7" ohmmeter Disconnect the wire from the terminal "–" battery. The vehicle can be fitted with an ignition coil type 29.3705 or 3012.3705. The coil has two...

Switch Replacement
You will need: key "on 10" screwdriver Before starting work: Disconnect the wire from the terminal "–" battery. The ignition system switch is located in the engine compartment and...

Checking the ignition switch
The ignition switch is equipped with an anti-theft device that locks the steering shaft when the key is removed. When turning the key from position "III" into position "0" the...

Removal and installation of the ignition switch
You will need: key "on 10" screwdriver Before starting work: Disconnect the wire from the terminal "–" battery. The ignition switch is attached to the steering column under the...

Ignition switch repair
You will need a screwdriver. Remove the ignition switch from the car ( see subsection 8.4.8. ). 1. Turn away the screw of fastening of facing and contact part to the case of the...