Clutch and drive shafts of cars VAZ-11113 «Ока»

Clutch repair
You will need: key "at 13" screwdriver hammer Remove the gearbox (see subsection 11.1.1.) . The reasons for incomplete disengagement of the clutch can be: warping of the driven...

Replacing the clutch release bearing
You will need a screwdriver. Remove the gearbox (see subsection 11.1.1.) . The reason for increased noise when disengaging the clutch may be wear or breakage of the clutch...

Replacing the clutch release fork
You will need a screwdriver. Remove the gearbox (see subsection 11.1.1.) and clutch release bearing (see subsection 11.2.2.) . Replace the clutch release fork if its deformation...

Guide bush replacement
You will need keys "on 10" And "at 13". Remove the gearbox (see subsection 11.1.1.) , clutch release bearing (see subsection 11.2.2.) and clutch release fork (see subsection...

Replacing clutch and brake pedal bushings
You will need: keys "at 19" (two) screwdriver Disconnect the wire from the terminal "–" battery. 1. Use a screwdriver to pry the retaining plate that secures the cable end to the...

Clutch cable replacement
You will need: keys "for 8", "on 10" (two), "at 17" (two) screwdriver The clutch cable is secured with a retaining plate on the clutch pedal. 1. Under the instrument panel, use a...

Clutch drive adjustment
Clutch drive adjustment unit: 1 – the lower tip of draft; 2 - locknut; 3 - adjusting nut; 4 - leash retainer; 5 - leash; 6 - clutch release fork You will need: key "on 10" (two)...

Removal and installation of front wheel drives
You will need: keys "on 10", "at 17", "at 19" ball joint pin puller large screwdriver hammer pliers Drain the gearbox oil. Loosen and loosen the wheel hub nut. Remove the relevant...

Replacement of constant velocity joints
Front wheel drive: 1 - internal ball joint; 2 – a protective cover of the internal hinge; 3 - drive shaft; 4 - protective cover of the outer hinge; 5 - outer ball joint You will...